Diff for "particle.io/ds1820"

Differences between revisions 3 and 4

particle.io wifi core, temperature monitoring using ds1820

Links ArduinoDS18B20TempSensors http://arduino-info.wikispaces.com/Brick-Temperature-DS18B20
bought a couple spark core's through a kickstarter project, name changed to particle.io
- been a bit disappointed, confusing documentation, lack of instructions, units stuck not connecting etc.
201512 got firmware flashed onto cores, the connect to internet and particle.io android ap can switch a led on and off, going to try one wire temperature monitoring again.
- https://www.hackster.io/AgustinP/logging-temperature-data-using-the-spark-core-b9c60c
201512 - four core cable to 3pin ds1020,
- pin1-GND(Yellow), pin3-vcc(Red), pin2-data(Green) with pull-up 4.7k resistor.
Go
1. login into web builder https://build.particle.io , i can see my devices.
2. start new project TempMon
  1. add libraries
    - ONEWIRE
    - SPARK-DALLAS-TEMPERATURE

...

-  ⇤ ← Revision 3 as of 2015-12-05 10:52:46 → 
  Size: 1001
  Editor: PieterSmit
  Comment:
+   ← Revision 4 as of 2015-12-06 00:47:55 → ⇥
  Size: 1097
  Editor: PieterSmit
  Comment:
-Deletions are marked like this.
+Additions are marked like this.
 Line 4:
- * Links [[ArduinoDS18B20TempSensors]]
+ * Links [[ArduinoDS18B20TempSensors]] [[http://arduino-info.wikispaces.com/Brick-Temperature-DS18B20]]
 Line 10:
- * 201512 - fourcore cable to 3pin ds1020,  {{attachment:ds1820-digital-temp.gif||align="top"}}
   * pin1-GND, pin3-vcc, pin2 - data with pullup 4.7k resistor.
+ * 201512 - four core cable to 3pin ds1020,      * {{attachment:ds1820-digital-temp.gif||align="top"}}
   * pin1-GND(Yellow), pin3-vcc(Red), pin2-data(Green) with pull-up 4.7k resistor.