833
Comment:
|
1375
|
Deletions are marked like this. | Additions are marked like this. |
Line 26: | Line 26: |
== OSPF problems == * Experienced problems where a router, connected to service provider MPLS using ospf area x, running vrf-lite, and connecting to area 0 on internal network would not show the area 0 routes. * Problem was caused by ospf superbackbone rules that kicked in due to putting the ospf instance in a vrf * Solution under ospf instance use command #capability vrf-lite * [[https://www.racf.bnl.gov/Facility/TechnologyMeeting/Archive/06-30-04-CISCO/Using-OSPF-in-MPLS-VPN-Environment.pdf|Ospf in MPLS VPN environment.]] |
VRF
- Visualizing a router. This is not about MPLS, although that is where the VRF concept comes from.
- Once a router has VRF software the interface must be upgraded to support VRF.
(config)#vrf upgrade-cli
- Sample Switch config with bgp and vrf.
Switch(config)# router bgp 800 Switch(config-router)# address-family ipv4 vrf vl2 Switch(config-router-af)# redistribute ospf 2 match internal Switch(config-router-af)# neighbor 83.0.0.3 remote-as 100 Switch(config-router-af)# neighbor 83.0.0.3 activate Switch(config-router-af)# network 8.8.2.0 mask 255.255.255.0 Switch(config-router-af)# exit
OSPF problems
- Experienced problems where a router, connected to service provider MPLS using ospf area x, running vrf-lite, and connecting to area 0 on internal network would not show the area 0 routes.
- Problem was caused by ospf superbackbone rules that kicked in due to putting the ospf instance in a vrf
- Solution under ospf instance use command #capability vrf-lite
...