370
Comment:
|
1227
Add info on vrf and ospf capability vrf-lite problems
|
Deletions are marked like this. | Additions are marked like this. |
Line 7: | Line 7: |
* http://www.shafagh.net/2009/10/vrf-lite.html |
|
Line 12: | Line 15: |
* Sample Switch config with bgp and vrf. {{{ Switch(config)# router bgp 800 Switch(config-router)# address-family ipv4 vrf vl2 Switch(config-router-af)# redistribute ospf 2 match internal Switch(config-router-af)# neighbor 83.0.0.3 remote-as 100 Switch(config-router-af)# neighbor 83.0.0.3 activate Switch(config-router-af)# network 8.8.2.0 mask 255.255.255.0 Switch(config-router-af)# exit }}} == OSPF problems == * Experienced problems where a router, connected to service provider MPLS using ospf area x, running vrf-lite, and connecting to area 0 on internal network would not show the area 0 routes. * Problem was caused by ospf superbackbone rules tha.t kicked in due to putting the ospf instance in a vrf * Sollution under ospf instance use command #capability vrf-lite |
VRF
- Visualizing a router. This is not about MPLS, although that is where the VRF concept comes from.
- Once a router has VRF software the interface must be upgraded to support VRF.
(config)#vrf upgrade-cli
- Sample Switch config with bgp and vrf.
Switch(config)# router bgp 800 Switch(config-router)# address-family ipv4 vrf vl2 Switch(config-router-af)# redistribute ospf 2 match internal Switch(config-router-af)# neighbor 83.0.0.3 remote-as 100 Switch(config-router-af)# neighbor 83.0.0.3 activate Switch(config-router-af)# network 8.8.2.0 mask 255.255.255.0 Switch(config-router-af)# exit
OSPF problems
- Experienced problems where a router, connected to service provider MPLS using ospf area x, running vrf-lite, and connecting to area 0 on internal network would not show the area 0 routes.
- Problem was caused by ospf superbackbone rules tha.t kicked in due to putting the ospf instance in a vrf
- Sollution under ospf instance use command #capability vrf-lite
...